Chipping instead of grinding!
As a result of the defined cutting edge geometry, no dust, in contrast to abrasive removal, but chips will occur.
This reduces a potential health- and explosion hazard to a absolute minimum in contrary to a grinding process.
The safest, most effective and economic solution for manual treatment of aluminium.
For processing of aluminium alloys with an angle grinder 115-125mm. The area of application is cross industrial, in container-, vessel and automotive manufacturing, as well as aluminium casting.
Most frequent is the pre- and post processing of welding seam (chamfering and trimming), the reaming of root seams as well as rough machining of cast iron parts.
- Workable materials: Aluminium alloys, copper, zinc, as well as timber and plastics (also fibre -reinforced plastic)
- No emerge of dangerous to health and explosive dusts
- The economic alternative to abrasive roughing- and flapwheels
- Very high material removal rate by simultaneous safe controllability
- Thanks to the polished chip guiding surface, no adhesions (buildup cuting edge)
- The carbide inserts are extremely durable as wel as reversible-and replaceable
- CNC milled from a solid piece of high strength aluminium
- Quality tool
Technical details:
- Dimensions: 115 x 20 x 22,2mm
- RPM max: 14.500 1/min
- Cutting material: Carbide (Carbide steel, sharpened)
- Tightening torque: 4Nm ( Screw T15 in M4 x 11 mm)
- Application: hand guided cutting tool "Manual"
- Packing: plastic case (200x235x45mm/510gr.) Torx-Allen key T15
- Accessory: Carbide insert 5 pcs set 24,5 x 11,7 x 3,0mm